APC/DI ECU access

• Unbolt the driver's seat
  • Run seat all the way forward
    • Remove two T50 Torx bolts from the rear of the rails at at the floor.  Picture
  • Run seat all the way back
    • Remove two T50 Torx bolts from the front of the rails at the floor.  Picture
  • Tilt the seat back
  • Disconnect the two connectors for the power seats.

   

• What you see, and what to do next
• What you see after you've done that
• Easier access
• Removing the connector
• For those who need to open the box

• Installation is the reverse of disassembly
  • Locate the notches in the bottom with the tangs on the baseplate
  • Rotate the front plate back into position
    • It clamps the ECU in place
  • Loosely install the Torx screws
  • Rotate the rear (black) plate into place, then install the 8mm hex head screws
  • Snug up all screws, then re-install the seat.